PENTENS T-304 High Elastic Cementitious Waterproofing
PENTENS T-304 is high elastic, thixotropic two pack material consisting of high solids polymer with modified cement bound mineral powder.
PENTENS T-304 is free from chlorides and any other corrosive substances.
ADVANTAGES
- Easy to apply
- Highly Flexible
- High water resistance
- Excellent adhesion
- Seamless, non-toxic
- Permeable to water vapor
- Ultimate weather resistance
USES
- Bathrooms
- Roof decks
- Balconies
- Water tanks
- External wall
PHYSICAL DATA
APPLICATION
Surface Preparation
All the surfaces, joint between slab and wall must be clean, free from grease, oil, laitance, and remove all the dirt and contaminants, which might affect adhesion.
Mixing
Add PENTENS T-304-B (25 kg powder) gradually to the PENTENS T-304-A (20 kg resin) and mix thoroughly until it blends completely with cement compound. Use mixture within 30 minutes.
Application
Substrate should be primed with a 1:3 mixture of PENTENS T-007 and water. Brush on at the approximate rate of 0.3 kg/m².
Apply or plaster first and finish coat of PENTENS T-304 to construction surface by using brush, roller of spray method. The time interval between plastering shall be 2~6 hours, and make sure that the first layer of plastering has been dried.
Curing
For optimum performance, PENTENS T-304 should be allowed to cure for 24 hours before the finishing concrete, tiles etc.
SAFETY
Impervious gloves and barrier cream should be used when handling these products.
Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist.
If contact with skin occurs, it must be removed before curing takes place.
Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent.
Ensure adequate ventilation when using these products.